Austin-hughes Automatic Transfer Switch Manual do Utilizador descarregar pdf (Página 5)

UM-IP-ATS-Q215V1

www.austin-hughes.com

< 1.3 > Installation

Don’t exceed the outlet, branch or phase limitations

All electrical power and power control wiring must be installed by a qualiﬁ ed electrician

and comply with local and national regulations.

■ It is very important to mount the equipment in a suitable cabinet or on a stable surface.

■ Make sure the place has a good ventilation, is out of direct sunlight, away from sources of excessive

dust, dirt, heat, water, moisture and vibration.

Before Installation

Use the provided screws to attach the mounting bracket set

( set of 3 ).

Step 1

screw

Use the M6 screw set to secure the ATS to your rack

( M6 screws not provided ).

Step 2

Cable

tie

Use the cable ties to fasten each power cord to the

cord retention tray ( cable ties not provided ).

Step 3

P. 3

1 2 3 4 5 6 7 8 9 10 11 12

Sem comentários

Austin-hughes Automatic Transfer Switch Manual do Utilizador Página 5